Biamp TesiraFORTE Operación Manual página 7

1. AC power inlet
2. Gigabit Ethernet control port (RJ-45)
3. AVB port (RJ-45) – AVB models only
4. RS-232 serial port
5. USB-B port
AC Power Inlet
IEC connector which will accept AC mains voltage of 100-240VAC @50/60Hz.
Gigabit Ethernet Port
Used to configure the TesiraFORTÉ unit with Tesira and BiampCanvas™ software. Can also be used to receive third-
party commands over IP.
AVB Port (AVB models only)
Can send and receive up to 128x128 audio channels to other Tesira audio devices.
RS-232 port
Can be used to receive third party controls or output command strings.
USB- B port
Can be used to connect to a PC or a computer that is USB Audio Class 1 compliant. Three connection methods are
supported:
1. Connection to a software based codec where the Tesira device does make use of AEC such as the TesiraFORTÉ
CI, TI and VI.
2. Connection to a software based codec which does not use Tesira AEC functions – such as a TesiraFORTÉ AI.
3. Line In/Out mode – where the channels of Line In and Line Out are installed in Microsoft Windows® but do not
show up by default.
All manuals and user guides at all-guides.com
TesiraFORTÉ FIXED I/O SERVER DEVICES REAR PANEL
TesiraFORTÉ AVB TI model shown
6. GPIO connections
7. Mic/line level output balanced analog
connections
8. Mic/line level input balanced analog
connections.
9. Telephony port
AVB AI and AI – Mic/Line
AVB CI, TI, VI and CI, TI, VI – Mic/Line with
Sona AEC
AVB AI, CI and AI, CI – Not available
AVB TI and TI – 1 analog telephone line
(RJ-11) AVB VI and VI – 2 VoIP telephone
lines (RJ-45)