Ego Power+ STA1500 Manual Del Operador página 13

PROBLEM CAUSE
◾
The motor shaft or trimmer head
is bound with grass.
◾
There is not enough line on the
spool.
◾
The trimmer head is dirty.
Trimmer head will
not advance line.
◾
The line is tangled in the
trimmer head assembly.
◾
The line is too short.
◾
Grass wraps around Cutting tall grass at ground
trimmer head and level.
motor housing.
◾
The line-cutting blade on the
The blade is not
edge of the guard has become
cutting the line.
dull.
◾
Cracks on the The trimmer head is worn out.
trimmer head or the
lower cover
assembly comes
loose with spool
base.
◾
During line re- The string line is not correctly
placement, the line inserted into the mounting hole
can't be loaded into in the eyelet.
the trimmer head
properly.
WARRANTY
EGO WARRANTY POLICY
Please visit the website egopowerplus.com for full terms and conditions of the EGO Warranty policy.
SOLUTION
◾
Stop the trimmer, remove the battery, and clean the
motor shaft and trimmer head.
◾
Remove the battery and replace the cutting line;
follow the section "LINE REPLACEMENT" in this
manual.
◾
Remove the battery and clean the spool, lower
cover assembly and upper cover.
◾
Remove the battery, remove the line from the spool
and rewind; follow the section "RELOAD THE
CUTTING LINE" in this manual.
◾
Remove the battery and pull the lines manually
while alternately pressing down and releasing the
trimmer head.
◾
Cut tall grass from the top down, removing no more
than 20 cm in each pass to prevent wrapping.
◾
Sharpen the line-cutting blade with a file or replace
it with a new blade.
◾
Replace the trimmer head immediately; follow the
section "TRIMMER HEAD REPLACEMENT" in this
manual.
◾
Align the LOAD lines with the eyelets firstly, then
insert the line into the mounting hole, which is
located inside the eyelet.
LINE TRIMMER ATTACHMENT — STA1500
EN
13