BLACK&DECKER MS2000 Manual De Instrucciones página 7

Large detail sanding base
With this sanding base, you can use the tool
as a detail sander or a flush sander.
Attaching the large detail sanding
base - figures E & f
For detail sanding, the pointed end should
face forward as in figure E.
For sanding large areas, the pointed end
should face to the back as in figure F.
• Attach the sanding base as described
above under "Attaching the random orbit
sanding base"
• Press in on the sanding base until you
hear it click into place.
fitting sanding sheets - figure G
• Detach the two diamond-shaped tips (12)
from the sanding sheet (13).
• Hold the tool with the sanding base facing
upwards.
• Place the sanding sheet (13) onto the
sanding base, making sure that the holes
in the sheet line up with the holes in the
base.
The diamond-shaped tip (12) can be
reversed and replaced when worn.
• When the front part of the tip is worn,
detach it from the sheet, reverse it and
press it onto the sanding base again.
• When the whole tip (12) is worn, remove it
from the sanding base and fit a new tip (12).
Tip of the sanding base - figure h
When the sanding tip (14) is worn, it can be
reversed as shown in figure H.
• The tip (14) can be removed and reversed.
e
f
13
G
12
h
7
15
14