cowin KY07 Guia Del Usuario página 6

1. When the charging case is not plugged into the USB charging state,
open the charging case, the earbuds are powered on automatically.
The blue light flashes, and the left and right earbud are automatically
paired.
1. Put the earbuds into the charging case and close the cover, the
earbuds will automatically power off.
* If The left or right earbud isn't connected to the device for about 5
minutes, the earbuds will automatically power off.
1. Open the charging case and remove the earbuds;
2. The left and right earbud automatically turn on and pair. Until the left earbud light off, the right earbud flash red and blue
light alternately, the earbuds pairing is successful;
3. Open the device Bluetooth search "KY07" and click to finish connect;
4. If the connection fails, put the earbuds back in the charging case and repeat the above steps.
NOTE
1. If the earbuds are currently or had already been connected to a Bluetooth device, click "forget" or remove "KY07" from your
Bluetooth settings and turn off Bluetooth on your device.
2. Put the earbuds into the charging case, plug in the charging cable to charge the earbuds, then press and hold the touch
panel for 5 seconds, red and blue light alternately flashing once to clear the Bluetooth pairing record.
3. Then unplay the USB cable and close the charging case,repeat daul mode steps.
1. Take the right earbud out of the charging case and turn on automatically; Until the red
and blue lights alternately flash into pairing mode.
2. Open the device Bluetooth search "KY07" and click to finish connect.
3.If the connection fails, put the earbuds back in the charging case and repeat the above
steps.
NOTE Only right earbud can be used as single mode.
* After the first connection, the earbuds will automatically connect back to the last-paired
device (Device Bluetooth needs to be turned on).
When the earbuds are connected to the device normally. If you want to connect another device, press the touch panel of the right
earbud 6 times continuously. When the red and blue lights alternately flash, enter the forced pairing mode,then you can connect another
device.
Support IOS/Android mobile phone displays the earbuds battery level near the upper right corner of the screen.
KY07
-5-