Mitsubishi Electric PAR-33MAA Operación Manual página 31

4
Weekly timer
Mon Tue Wed Thu Fri Sat Sun
No.
Input display:
day
F1 F2
5
Weekly timer
No.
Select:
Cursor
F1 F2
Weekly timer
Changes saved
Day selection:
Room
Cool
Mode
Select Page
F3 F4
Thu
6: 3
On
1 : 2 - 27
Auto
Content
F3 F4
Thu
Fri
Set temp. Auto
Temp. Fan
The weekly timer setting screen will appear and
the current settings will be displayed.
Up to eight operation patterns can be set for
each day.
Move the cursor to the desired day of the week
with the F1 or F2 button, and press the
F3 button to select it. (Multiple days can be
selected.)
Press the SELECT button.
Operation pattern setting screen will appear.
Press the F1 button to move the cursor to the desired
pattern number.
Move the cursor to the time, On/Off, or temperature
with the F2 button.
Change the settings with the F3 or F4 button.
• Time: settable in 5-minute increments
* Press and hold the button to rapidly advance the numbers.
• On/Off/Auto: Selectable settings depend on the model of
connected indoor unit. (When an Auto pattern is executed,
the system will operate in the Auto (dual set point) mode.)
• Temperature: The settable temperature range
depends on the connected indoor units. (1ºC increments)
When the Auto (dual set point) mode is selected, two preset
temperatures can be set. If an operation pattern with a single
preset temperature setting is executed during the Auto
(dual set point) mode, its setting will be used as the cooling
temperature setting in the Cool mode.
Press the SELECT button to save the settings.
A confirmation screen will appear.
Navigating through the screens
• To go back to the setting change/day of the week
selection screen ............................. SELECT button
• To go back to the Main menu .......... MENU button
• To return to the previous screen ...... RETURN button
will appear on the Main display in the Full
mode when the weekly timer setting for the
current day exists.
The icon will not appear while the On/Off timer
is enabled or the system is under centralized
control (Timer operation from local remote
controller is prohibited).
31