Cleaning And Maintenance; External Cleaning - KLIM FRESH Manual Del Usuario

CLEANING AND MAINTENANCE

It is recommended to clean the cooler regularly after prolonged use, or when using it for the first
time following a long time in storage.
Always turn off the cooler and disconnect the plug before
performing any cleaning or maintenance operations
power before manipulating the water deposit!
Cleaning the air filter & evaporation panel
Dust and dirt may accumulate in the filter and evaporation panel, adversely affecting the
cooler's performance and sometimes causing unwanted odour. Clean them at least once a
month for the best results.
1. Remove the two screws at the back
(pic. 1)
2. Press the central button and remove the
filter and panel block(pic. 2)
3. Take the panel by pushing the frame to
the sides to make room (pic. 3)
4. Rinse the filter and evaporative panel,
clean them with mild detergent and
leave to dry
5. Once dry, place the panel in the frame.
6. Attach the frame to the cooler and
secure the two screws again (pic. 4)
Cleaning the water deposit
1. Open the water deposit as instructed in the previous page.
2. Turn the water pump locks and detach the pump (see picture)
3. Completely remove the water deposit, take out the ice bottles
(if present) and empty any remaining used water.
4. Clean the deposit using a wet cloth and a non-abrasive
cleaning agent.
5. Insert the water deposit ⅓ in, reattach the water pump and
secure it by rotating the locking mechanism
6. Close the water deposit completely and rotate the deposit
lock.

External cleaning

Wash the cooler body with mild detergent and a soft cloth. Do not spray or rinse water directly on
the cooler's surface or control panel. Completely dry the cooler before plugging it again.
Picture 1
2
1
Picture 3
5
Picture 2
Picture 4
Water pump removal