T Ools; P Reventive Maintenance; T Roubleshooting - SUHNER MACHINING MAX 100 Documentación Técnica

3
Completely unscrew the screws (1) and remove the motor
assembly with flange and pulley (2). Remove the sheet
metal (3).
3 1 2
Remove the pulley (1) from the motor shaft and replace
the spacer (2) and washer (3) with those corresponding to
the U-shape. Reassemble the pulley on the motor shaft.
2 1
Reverse the elements and reassemble them in the follow-
ing order: sheet (1), motor assembly (2), belt tensioning
screw (3), sheet (4).
1 2
3.2 t
receivers.
Use the attachments intended for each application. Do
not trim attachments for applications they have not been
designed for.
Always use speeds and feed rates assigned to the attach-
ment and material, and do not exceed the machine's and
the tool's max speed.
Never remove chips with your bare hand, but always use
e.g. hooks, etc.
4.1 p
3 4
dental reactivation. To perform work on the motor (e.g.
changing from one side to the other) or inside the switch-
box, after the machine main power switch has been
turned off it is necessary to wait for a period of ten min-
utes. The charged capacitors in the frequency converter
need this time to completely electrically discharge.
The machine is fitted with lifetime lubricated bearings and
is maintenance free.
Check the belt drive for damage every 400 operating
hours.
4.2 t
In the event of malfunctions, contact an authorised SUH-
NER aftersales service centre.
ools
Handle tools and attachments with care, keep
them clean and sharp, and observe the manufac-
turer's instructions on the use of coolants and tool
4. s /M
ErvicE
reventIve maIntenance
As soon as maintenance or repair work
starts, disconnect the machine from the
power supply, and secure it against acci-
roubleshootIng
aintEnancE
29