Beper P101PIA002 Manual De Instrucciones página 7

Electric Hot Plate Use instructions
This appliance is for household use only.
To protect against electric shock, do not immerse cord, plug or any
parts of the appliance into water or other fluids.
Do not use the appliance near explosives, highly flammable mate-
rials, gases or burning flames.
Do not allow children, disabled people or every pe-
ople without experience or technical ability to use
the appliance if they are not properly watched over.
Close supervision is necessary when any appliance
used by or near children.
Use advice
Never leave oil and fat to be heated without supervision.
Do not touch the surface of the plate when the appliance is in use or getting hot.
The plate has been manufactured only for heating or cooking food. It is recommended to use the plate when the
fry pan is already placed on it.
Do not use the appliance in open space/outdoors.
The product is for home use only.
Pot type
To optimize the use of the hot plate, the pots should have a solid bottom thickness and possibly a diameter
between 8 cm and 12 cm up to a maximum of 2.5 litres of capacity.
Pot with a flat bottom and the same diameter of the hot plate, is the best solution as absorbs
the heat of the cooking plate very well.
If the pan is too small, there will be considerable heat loss and the performance of the product
will be compromised.
If the pan is too large, the heat transfer from the plate to the bottom of the pan will be too low
and the performance of the product will be compromised.
Use
When using the hot plate for the first time, connect the plug to the socket and turn the hot plate to the highest
temperature for 3-5 minutes to eliminate the smell and smoke that the protective substances present on the
metal parts can develop.
Turn on the appliance by turning the switch. When the light indicator turns on, the appliance is in use.
Turn the switch to get desired 5 levels of :
1. Slow cooking, delicate piece of food, thickening sauces, etc.
2. For simmering large quantities
3. Shallow trying of meat
4. To bring all dishes to rapid heat
5. To bring all dishes to boil
The light indicator turn off when the hot plate reaches the selected temperature.
Do not use the appliance for more than one hour.
During use, do not leave the electric cable dangling and/or in contact with the hot surfaces of the product.
When the appliance is not in use, check that the thermostat position is at minimum and disconnect from the
mains.
Leave the appliance cooling down before storing.
7
EN