Hisense HGH641SS Manual De Funcionamiento Para El Usuario página 14

How To Use Your Appliance
The position of the corresponding gas burner is indicated on each control knob.
GAS BURNERS
The burners differ in size and power. Choose the most appropriate one for the diameter of the cookware being used.
The burner can be regulated with the corresponding control knob by using one of tile following settings:
It is prohibited to adjust the flame in the range between the Burner OFF and Burner ON large flame positions.
IGNITING THE BURNERS
In these models the knob controls both ignition and the safety device. Proceed as follows to ignite the burners:
1) Turn the chosen knob.
2) Keep the knob strongly pressed in for 3/4 seconds to permit the spark to light the gas that exits from the flame tamer and to
permit the thermocouple to heat up. Rotating the knob anti-clockwise direction to the "High" setting.
3) Release the knob after about 3/4 seconds and adjust the flame as desired,
Repeat points 1 and 2 if the flame does not remain on.
Caution: If the burner accidently goes out, turn off the gas with the control knob and try to light it again after waiting at least I minute.
Turn off a burner, turn the knob in the clockwise direction until it stops (it should be on the "
USING THE BURNERS
For greater efficiency and less gas consumption use pots and pans with the right diameters for the burners. Avoid having flames extending
out from underneath the pans (refer to the table).
AUTOMATIC SAFETY VALVES
This safety device automatically closes the gas valve if the inconvenience caused by failure to comply with this rule.
Table of recommended pans
Burner
Auxiliary
Semi rapid
Rapid
Triple ring
" setting).
Ø Pan diameter in cm
from dia. 8 to dia. 14
from dia. 14 to dia. 20
from dia. 20 to dia. 28
Above dia. 26
2