HAMPTON BAY 17666 Guía De Uso Y Mantenimiento página 5

Assembly (continued)
Connecting the small tube and
3
handle to the arm assembly
Tighten the small tube (E) onto the arm assembly (A).
Insert the handle (D) into the arm assembly (A) as shown
and secure the two hex screws (G) by using the hex wrench
(F).
5
Installing the shade
Unscrew the socket ring (C) from the socket of the arm
assembly (A), and place the shade (B) onto the socket.
Replace and tighten the socket ring (C).
Loosen the knob on the side of the arm assembly (A) to
adjust the arm to the desired location then tighten the knob
to lock into place.
Tilt the socket on the arm assembly (A) to the desired
location.
NOTE: Remove the plastic cover on the shade before using.
Connecting the small tube, handle
4
and arm assembly to the upper
tube
Insert the small tube (E) into the upper tube (H) as shown
and secure the three hex screws (G) by using the hex
wrench (F).
NOTE: Do not twist the power cord (L).
6
Installing the light bulb
Screw the 15W maximum 3-way LED bulb (M) into the
socket assembly (A).
You can also use one 100W maximum 3-way
NOTE:
standard Type A bulb (sold separately). Do not exceed
the recommended wattage.
5
l P a e e s o c t n c a 1 t
H A M P
8 - 5 5 H - D H - A M P O T N r o f u f t r e h
O T N B Y A C . O M
a r s s s i a t c n . e