Troubleshooting - Airthereal Glory Days AGH430 Manual Del Usuario

TROUBLESHOOTING

Problem
No power or
response.
Unpleasant Smell.
The air quality
indicator always
gets in red.
The numbers have
been fluctuating
from 3 to 15.
Any faulty display of
the LED numbers.
Unusual noise while
operating.
12
Cause
The unit is not plugged into
an electrical outlet.
The outlet is not working
properly.
The power adapter is
damaged.
The air purifier is defective
or malfunctioning.
The filter may be too dirty
if it's used for a long time.
Using the air purifier in
moist conditions or water
entered in the filter.
Dirty filters and room air is
bad.
This PM2.5 sensor is very
sensitive.
Auto Mode has just been
turned on.
The unit is defective or
malfunctioning.
Dirty filters.
Filters installed improperly.
The foreign object inside
the unit.
Flimsy or slanted surfaces
resulting in an abnormal
noise and vibrations.
Solution
Connect the plug to a powered electrical
outlet.
Try plugging the air purifier into a different
outlet.
Immediately discontinue use and contact
Customer Support.
Replace the filter.
Replace the filter.
It means the air quality is good when
the value is under 15. You need to pay
attention when it goes higher than 30.
Allow the air purifier to run for 10-15 seconds.
They will change a stabilized status based
on the detected air quality.
Immediately discontinue use and contact
Customer Support.
Replace the air filters as instructed in the
Replace the Air Filters section.
Place the filter properly. Please refer to
the Getting Started and Replacing the
Air Filters section.
Immediately discontinue use and contact
Customer Support. DO NOT attempt to
open the air purifier yourself.
Place the air purifier on hard, flat surfaces.