Galletti EVO Manual Del Usuario página 3

EVO
Fc66003563
rev 00
electronic board
install the i/o board on 2X1, ESTRO, FLAT
and UTN units using the relative clamping
bracket and the supplied 9.5 mm screws.
Screw the 3-way terminal board onto the
bracket using the supplied 25 mm screws;
install the bracket onto the side of the unit
that is opposite the water infeed/outfeed
manifolds.
on the PWN unit, install the i/o board
directly onto the electrical connections box
using the supplied 9.5 mm screws.
set up the electrical connections as
illustrated in the electrical diagram; use the
cable with a 1.5 mm
unit terminal board (cn) to the board
UsER MaNUaL
it is strictly forbidden to reproduce this manual, even partially
section to connect the
2
en
3