WoodCrafters 2700 Instrucciones De Montaje

INSTALLATION INSTRUCTIONS
BATHROOM CABINETS
DETERMINE WHERE TO PLACE THE VANITY
1. Determine where the vanity will be located. Fasten the vanity to the wall with appropriate
wood screws (not provided) into wall studs or solid lumber through the back rail,
or use toogle bolts if necessary.
2. The drawer knobs are turned inside out to avoid damage in transit. Knobs must be
reattached on the outside of the cabinet to be functional.
3. Door pulls are normally stapled to the top back rail (inside a plastic bag).
4. Use the adjustment chart below to align your cabinet fronts.
CARE & MAINTENANCE:
Cleaning Instructions: To clean surface of doors or cabinet, use non-abrasive cleansers only.
HINGE / DOOR ADJUSTMENT
Adjust door height
Adjust door left
or right
Adjust gaps between
doors
DRAWER FRONT ADJUSTMENT
NOTE: Decorative hardware and alignment system screws are located inside the drawer box.
1. Remove decorative hardware from the drawer front.
2. Hold drawer front in place and slightly loosen both alignment screws.
3. Move the drawer front left, right, up or down to desired position for alignment.
4. While holding the drawer front in place, tighten the alignment screws securely.
5. Install the decorative hardware to the outside of the drawer front.
2700 Camino de Verdad
Weslaco, TX 78596
1 (800) 235-7747
Top Back Rail
Alignment System
Drawer Box
Drawer Front
Decorative Hardware
Alignment Screws
Screws