Publicidad
Idiomas disponibles
Idiomas disponibles
Step 10: Connect the CORNER TOP PANEL [K] to the TOP [A] with 6 SMALL SCREWS
[Q]. See Fig. 10
Step 11: Install the TOP [A] to the unit with 3 MEDIUM KD SCREWS [V] as shown in
Fig. 11.
Step 12: Tighten all SCREWS.
FIREPLACE INSERT INSTALLATION:
The fireplace insert can be installed after the mantle has been fully assembled.
WARNING: mAKE SURE THE FIREPLACE INSERT CONTROLS ARE IN THE
OFF POSITION AND THE UNIT IS NOT PLUGGED IN.
All manuals and user guides at all-guides.com
fig. 9
fig. 10
fig. 11
Step 1: Place the INSERT in FRONT of the mantle on the floor. Carefully lift the INSERT
into the mantel until the trim is against to MANTEL. See fig. 12
Step 2: Attach 4 MEDIUM BRACKETS [U] to the bottom of insert with 4 MEDIUM KD
SCREWS [V] as shown in Fig. 13
Step 3: Tighten all screws.
Step 4: Move assembled unit to desired location. Unit should not be positioned in area
exposed to direct sunlight.
WALL ANCHOR SAFETY CABLE
The use of WALL ANCHOR SAFETY CABLE is highly recommended in order to reduce
the risk of the fireplace being tipped over accidentally. WARNING: This CABLE may
reduce possible risk of injury if the fireplace is improperly handled, but is not a
substitute for proper adult supervision. Children should not be left unattended near
any heater.
1. Drill a 5/16" (8mm) hole in the wall. Insert the PLASTIC WALL ANCHOR into the
hole and gently tap until the flange on the anchor is against the wall surface.
2. Position the back edge of the mantle close to the wall.
3. Attach the SAFETY CABLE to the mantle using the SCREW FOR MANTLE. See figure
14 and 15.
fig. 12
fig. 13
Publicidad
