cam SMARTY Manual Del Usuario página 15

INSTRUCTIONS FOR SAFE USE
IMPORTANT! KEEP THEM
FOR FUTURE REFERENCE
IMPORTANT INFORMATION
1) WARNING: never leave your child unattended.
2) WARNING: always use the restraining system and ensure the harness is
correctly fitted.
3) WARNING: always use the fitting mechanism onto the chair and ensure it
is correctly assembled prior to use.
4) WARNING: Once the booster chair is fitted, always check it is stable and
safe before using.
5) Do not use the product on stools, benches and folding chairs.
6) WARNING: this product is recommended for babies who can sit unaided,
up to 3 years of age or weighing not more than 15 kg.
7) Do not use the booster chair if any parts are broken, torn or missing.
8) Use replacement parts supplied by the manufacturer only.
9) Use this product on a chair only and with all restraining systems fitted as
shown in the manual.
10) Cam Il Mondo del Bambino SPA reserves the right to amend the product
for technical or commercial reasons.
11) Make sure that both the floor and the chair surface are flat before using
the product.
12) Always use the product as it has been conceived; on the contrary the
producer will not be held responsible for any misuse.
13) WARNING: ensure that the adult chair whit the chair mounted seat is
placed in a position where the child is not able to use its feet to push against
the table or any other structure as this can cause the tip over.
THIS PRODUCTS CONFORMS TO THE REQUIRED SAFETY STAN-
DARDS. - EN 16120:2012
INSTRUCTIONS FOR SAFE USE
- Assemble the 4 feet as described in fig. 1.
OPENING THE PRODUCT: Lift completely the backrest (fig. 2). Avoid putting the backrest in the
incorrect position (fig. 2A). When reaching the correct position of the backrest, you will hear a "click"
(fig. 2B). To open the booster seat frame, push the 2 buttons "B", while pushing down the frame at the
same time (fig. 3). Thanks to its locking mechanism, the booster seat frame is adjustable in different
heights (fig. 3A).
ASSEMBLING THE TRAY (optional)
- Insert the 2 plastic parts "C" of the tray on the armrests' slots (fig. 4).
- Turn the tray towards the direction of the arrow and insert the buttons "T" on the housings "L", placed
on the sides of both armrests (fig. 4A).
ASSEMBLING THE SAFETY HARNESS
Carefully examine picture 5 to establish the difference between each kind of harness / strap.
Strap "A": - Insert the 2 D rings of the waist strap "A" into the relevant slots 1 and 2 placed on the
lower part of the backrest (fig. 6).
- Before inserting the D ring, turn it as to make it pass through the slot (Fig. 6A).
- Insert the D rings one after the other into the slots (fig. 6B).
15