Operating Features - Urmet 1092/271 Guía Rápida

ENGLISH
INSTALLATION
1. Before start installation, check that all the devices to be connected are not powered.
2. Remove the protection dome by unscrewing with the provided spanner the three locking screws.
Make 3 fixing holes (for false-ceiling mounting, make also a 15mm diameter hole for passage of
cables), using the minidome as drilling template.
3. Fix the minidome to the surface with the provided
screws.
Note: If the dome is not false-ceiling mounted, unscrew the cables passage screw on the dome side.
4.
Connect the video output to the selected terminal device.
5.
Connect the power JACK to the power supply unit and power-on the camera
6.
Adjust lens angle, slant and rotation, in order to capture correctly the selected images
7. Loosen with a slotted screwdriver the adjusting rings for focus and varifocal adjustment.
•
Rotate to WIDE "W" to zoom out the subject (consequently, field and viewing angle are increased).
•
Rotate to TELE "T" to zoom in the subject (consequently, field and viewing angle are reduced).
•
Rotate to NEAR "N" to adjust focus of a near subject.
•
Rotate to FAR "∞" to adjust focus of a distant subject.
Adjusting ring for focuing
VARIFOCAL adjusting
ring
8. After focusing and varifocal adjustment operations, tighten again the adjusting rings in order not to
change the adjustments just performed.
9. Use the menu button inside the minidome (see following paragraph)
10. Fix the protection dome to the minidome base, by screwing the three previously removed screws

OPERATING FEATURES

MENU setting
4
FIXING HOLES
75°
360°
Check pin of adjusting focus
ring
Check pin of VARIFOCAL
adjusting ring
UP
LEFT
SET
DOWN
360°
RIGHT
DS1092-197