Led Indicators; Basic Functions - Jam TWS Exec Folleto De Instrucciones

USING YOUR PORTABLE CHARGING CASE
With a full charge, your portable charging case will give your earbuds 25
extra hours, giving you up to 32 hours total of listening time.

LED INDICATORS

EARBUDS IN CHARGING CASE
Solid red
LED off
PORTABLE CHARGING CASE
Flashing Blue
4 LEDs on
EARBUDS IN USE
Flashing red and blue
alternatively
Slow flash blue
EARBUDS IN MONO USE
Flashing red and blue
alternatively
Slow flash blue
TROUBLESHOOTING
1. Disconnect and forget the TWS Exec on your Bluetooth
device. Please view the device instruction manual for
instructions on how to forget a device.
on your device.
2. Turn off Bluetooth ®
3. Make sure earbuds are in the charging case.
4. Quickly tap the touch sensors on both earbuds 3 times, at the
same time. This will reset your earbuds.
5. Remove both earbuds from the charging case.
6. Earbuds will automatically go into pairing mode once they are
taken out of the case. The LED on the left earbud will flash red
and blue alternatively. This means they are ready to pair.
on your device.
7. Turn on Bluetooth ®
8. Pair to "JAM TWS Exec"
9. Earbuds not disconnecting from your device? The TWS
Exec earbuds may automatically connect to your device if
put in a charging case that has no battery left. For the best
experience, periodically charge the case to ensure it always
has battery life.
EN
Charging
Charging complete
Charging
Charging complete
Earbuds are sync with each
other and in pairing mode
Earbuds are paired with
device
Earbud is in pairing mode and
searching for a device
Earbud is paired with device
®

BASIC FUNCTIONS

MUSIC
Play/Pause
Forward Track
Back Track
CALLS
Pick up a call
Decline a call
End a call
Take a second incoming call
Decline a second incoming
call
Swap between 2 calls
OTHER
Activate Voice Assistant
Turn off earbud
Disconnect all Bluetooth ®
connections and reset
earbuds
Press either touch sensor
button once
If using both earbuds, tap the
touch sensor twice on the right
earbud. If using one earbud,
tap the touch sensor twice of
the earbud in use
If using both earbuds, tap the
touch sensor twice on the left
earbud. Note that back track
does not function when using
only one earbud
Tap either touch sensor once
Press and hold either touch
sensor for 2 seconds
Tap either touch sensor once
Tap either touch sensor once
Press and hold either touch
sensor for 2 seconds
Press and hold either touch
sensor for 2 seconds
Quickly press either touch
sensor 3 times
Press and hold touch sensor
for 5 seconds or place in
charging case
Place both earbuds in the
charging case, then quickly
tap the touch sensors on both
earbuds 3 times, at the same
time
5