Publicidad
Idiomas disponibles
Idiomas disponibles
Assembly / Installation
INTRODUCTION
Flotec extra-capacity filters maintain a natural balance,
clear water, and healthy fish and plants in your pond.
Pond pollutants can accumulate at the bottom of the
pond. The pollutants dissolve into the pond water, pro-
ducing harmful toxic by-products. These by-products will
affect fish health and cause cloudy water. The extra-
capacity filter has been specifically designed to remove
harmful pollutants by converting them into harmless
gases which will evaporate into the atmosphere. No
chemical additives are required.
How it works
As pond water enters the filter, it flows in and around the
®
patented Flocor
filter media. This filter media is
designed to offer a large surface area for the colonization
of "friendly" bacteria that will consume harmful toxins in
the water. Water clarity is increased because the filter
removes the nutrients that algae and blanketweed thrive
on.
ASSEMBLY
The extra capacity pump filter is designed to connect to
the intake of any Flotec garden pond pump. Remove the
existing inlet filter housing and sponge that was original-
ly supplied with your pump before installing the extra
capacity inlet filter. This is accomplished by gently twist-
ing the existing inlet filter housing clockwise and pulling
outward at the same time.
The extra capacity pump filter is connected to the inlet of
the pump with the hose supplied. An adapter is also sup-
plied for connection to some models of pumps (Table 1).
On smaller pumps the adapter fits over the outside of the
pump inlet and on larger pumps the adapter fits inside of
the pump inlet.
FLOTEC warrants to the original consumer purchaser ("Purchaser") of its products
that they are free from defects in material or workmanship.
If within twelve (12) months from the date of the original consumer purchase any
such product shall prove to be defective, it shall be repaired or replaced at FLOTEC's
option, subject to the terms and conditions set forth below. Your original receipt of
purchase is required to determine warranty eligibility.
Exceptions to the Twelve (12) Month Warranty
Ninety (90) Day Warranty:
If within ninety (90) days from original consumer purchase any Drill Pump, Pitcher
Pump, or In-Line Water Filter Cartridge shall prove to be defective, it shall be
replaced, subject to the terms set forth below.
Two (2) Year Warranty:
If within two (2) years from original consumer purchase any 1/3 HP Submersible
Sump Pump shall prove to be defective, it shall be repaired or replaced at FLOTEC's
option, subject to the terms and conditions set forth below.
Three (3) Year Warranty:
If within three (3) years from original consumer purchase any 4" Submersible Well
Pump, or 1/2 HP Submersible Sump Pump, shall prove to be defective, it shall be
repaired or replaced at FLOTEC's option, subject to the terms and conditions set forth
below.
Four (4) Year Warranty:
If within four (4) years from original consumer purchase any FLOODMATE 7000
Submersible Sump Pump shall prove to be defective, it shall be repaired or replaced
at FLOTEC's option, subject to the terms and conditions set forth below.
Five (5) Year Warranty:
If within five (5) years from original consumer purchase any Pre-Charge water system
tank shall prove to be defective, it shall be repaired or replaced at FLOTEC's option,
subject to the terms and conditions set forth below.
In Canada: Wicor Canada, 1800 Courtney Park Drive East, Unit 5-7, Mississauga, Ontario L5T 1W1
Flotec Limited Warranty
In the U.S.: FLOTEC / P.O. Box 342 / Delavan, WI 53115
INSTALLATION
The cover illustration shows a typical garden pond and
fountain installation with the use of the Flotec extra-
capacity filter. The filter can be placed at any location in
the pond that the hose length will reach, either above or
below the pump. The filter must be submerged at all
times when pump is running, or damage to the pump
will result.
Model
FPWG-180FK, FPWG-260FK
FPWG-400FK, FPWG-620FK
FPWG-750FK
FPWG-960FK, FPWG-1130FK
FPWG-1340FK
FPWG-1560FK, FPWG-2100FK
Adapter slips over pump suction
for fountain pump models:
FPWG-180FK
FPWG-260FK
FPWG-400FK
FPWG-620FK
Figure 1
General Terms and Conditions
Purchaser must pay all labor and shipping charges necessary to replace product cov-
ered by this warranty. This warranty shall not apply to acts of God, nor shall it apply
to products which, in the sole judgement of FLOTEC, have been subject to negli-
gence, abuse, accident, misapplication, tampering, alteration; nor due to improper
installation, operation, maintenance or storage; nor to other than normal application,
use or service, including but not limited to, operational failures caused by corrosion,
rust or other foreign materials in the system, or operation at pressures in excess of
recommended maximums.
Requests for service under this warranty shall be made by returning the defective
product to the Retail outlet or to FLOTEC as soon as possible after the discovery of
any alleged defect. FLOTEC will subsequently take corrective action as promptly as
reasonably possible. No requests for service under this warranty will be accepted if
received more than 30 days after the term of the warranty.
This warranty sets forth FLOTEC's sole obligation and purchaser's exclusive remedy
for defective products.
FLOTEC SHALL NOT BE LIABLE FOR ANY CONSEQUENTIAL, INCIDENTAL, OR
CONTINGENT DAMAGES WHATSOEVER.
THE FOREGOING WARRANTIES ARE EXCLUSIVE AND IN LIEU OF ALL OTHER
EXPRESS WARRANTIES. IMPLIED WARRANTIES, INCLUDING BUT NOT LIMITED
TO THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PAR-
TICULAR PURPOSE, SHALL NOT EXTEND BEYOND THE DURATION OF THE
TM
APPLICABLE EXPRESS WARRANTIES PROVIDED HEREIN.
Some states do not allow the exclusion or limitation of incidental or consequential
damages or limitations on how long an implied warranty lasts, so the above limita-
tions or exclusions may not apply to you. This warranty gives you specific legal rights
and you may also have other rights which vary from state to state.
Adapter Required
Yes (outside)
No
Yes (inside)
Adapter slips inside pump suction
for fountain pump models:
FPWG-1340FK
FPWG-1560FK
FPWG-2100FK
2
681 0495
Publicidad
