Filling The Water Tank - Air innovations CLEAN MIST MH-901DA Manual De Instrucciones E Información Sobre La Garantia

Filling The Water Tank

WARNING: Always unplug the unit before removing the Water Tank.
WARNING: DO NOT touch the water in the Base.
WARNING: Never turn Water Tank upside down when full.
1
Ensure the Water Tank is firmly seated on the
Base so there is no visible gap between Water
Tank and Base.
3
Fill the Water Tank using clean, cool, tap water.
Note: Do not fill past the fill line.
WARNING: DO NOT use extremely cold water,
since it may temporarily reduce the mist output.
WARNING: NEVER fill with hot/warm water or
use additives as this could damage the unit and
void the warranty.
WARNING: If you have hard tap water use
our Humidifier Demineralization
Filters (available at www.Air-Innovations.com) or
use ONLY filtered/distilled water.
5
Attach the Dual Directional Mist Nozzle or Extension Nozzle & Dual Directional Mist Nozzle together to the top of
the Water Tank. To easily control the direction of the mist simply separate the Dual Directional Mist Nozzle and
position as desired-see photo above.
Extension Nozzle – To convert this unit from a Tabletop unit to Floor unit simply remove the Dual
Directional Mist Nozzle from the top of the Water Tank. Place the unit on your desired floor area and
insert the Extension Nozzle into the top of the Water Tank. Then place the Dual Directional Nozzle on
the top of the 16" Extension Nozzle.
4
2
Use the Finger Lift to open the Water Tank Lid.
4
Close the Water Tank Lid.
block air holes as this will effect the performance of
the unit and void the warranty.
6
WARNING: NEVER