Safety instructions
Please read these instructions thoroughly before you
use the device and keep them for future reference.
This product is not a toy. Keep out of reach of
•
children.
Keep batteries out of the reach of children. Dispose of
•
batteries as chemical waste. Never use old and new
batteries or different types of batteries together.
Remove the batteries when you are not using the
system for a longer period of time. Check the polarity
(+/-) of the batteries when inserting them in the
product. Wrong positioning can cause an explosion.
Never open the product: the device may contain parts
•
with deadly voltage.
Repairs or service should only be performed by
•
qualified personnel.
Requirements
This product requires an 8 ~ 16 VAC 50 Hz power
source and a stable internet connection
(username/password).
Step 1a: Installation with your existing doorbell
1. Switch off the power supply to the existing doorbell
and check whether it meets the required supply voltage.
2. Remove the existing doorbell push button at the door,
the Buzz LO will be connected to it later.
3. Connect the supplied doorbell kit in parallel to the
existing mechanical chime, no matter which wire is
connected to the + or -. (You may need to temporarily
remove the protective cover of your mechanical gong for
this.)
Step 1b: Installation using a separate power supply
4
1. Switch off the power source and check whether it
meets the required supply voltage.
2. Pull two wires to the location where you'd like to place
the Buzz LO.
3. Connect the supplied doorbell kit in series to the
power supply, but do not yet switch on the power
supply.
Warning: not connecting the doorbell kit can cause
damage to the Buzz LO.
Step 2: Mount the Buzz LO at its location
Install the Buzz LO with or without using the supplied
corner bracket. See page 16/18 for a detailed
description.
Step 3: Install the Smart me app
1. Download and install the Marmitek Smart me app on
your smartphone or tablet.
2. Launch the Smart me app after the installation is
complete.
3. Follow the instructions and register for a new
account.
Step 4: Installation of the Buzz LO
1. Connect the Buzz LO to the 2 wires from step 1 and
then switch on the power supply (of the existing
doorbell or separate power supply).
2. After starting up, the status light will blink rapidly and
a tone will be heard. When the light does not blink,
press the reset button with the supplied pin for 5-6
seconds.
3. Start the Smart me app on your smartphone or tablet.
4. Click on the + (top right corner) to add a new device.
Click on the 'Cameras' category and select the Buzz
LO. Check that the status light blinks red rapidly and
follow the instructions on the display.
5. Scan the QR code by holding the code 15-20 cm in
front of the camera lens and confirm when you hear a
beep from the camera. During installation, press the
Help button for more information or if the installation
fails.
© MARMITEK