Programming With The Easy Base Unit; Configuration Parameters (Easy) - Gewiss CHORUS GW 10 756 Manual Del Usuario

PROGRAMMING WITH THE EASY BASE UNIT

4.
Programming the device through the Easy base unit (code GW 90 831).
The device to be used in the function that is to be created can be selected
at choice:
• locally by causing the detector to intervene: the corresponding channel
will be highlighted in the channel list in the "Application → New
function" or "Application → Edit function" menu;
• directly from the list of channels of the "Application → New function" or
"Application → Edit function" menus.
The function can be created after the device has been selected.
Names of the functions on the Easy base unit
timer mode
Refer to the Easy base unit documentation for further information on the
programming procedures.
4.1

CONFIGURATION PARAMETERS (EASY)

After creating the desired function, it is possible to configure the device
function parameters from
The parameters available, in relation to the function created, are
the following table.The underlined value is the default value.
Function: timer mode
Parameter: transmission period
10s
30s
45s
1m
2m
5m
Function: timer mode
Parameter: keep move. applica.
disabled
enabled
command ON with timer
(the time is set on the actuator)
the "Application → Parameters" menu.
cycle time – 10 seconds
cycle time – 30 seconds
cycle time – 45 seconds
cycle time – 1 minute
cycle time – 2 minutes
cycle time – 5 minutes
conditioned detection deactivated
conditioned detection activated
21
listed in