Publicidad
Idiomas disponibles
Idiomas disponibles
GB Instructions for use
Power:
700 W
Consuption: 82.5 g/h
Category:
Butane direct pressure
Jet:
0,15 mm.
This product works with a butane 190 gr gas
cartridge BTP C200 SUPER-EGO. It can be
dangerous to use different kind of gas cartridge.
Use this appliance in sufficiently ventilated
rooms. N.B. This lamp is not suitable to be used
hanged on inflammable surfaces.
IMPORTANT WARNING FOR THE USE AND
MAINTENANCE OF THE LAMP
• When first lighting the lamp, or if the
appliance has been shaken, there is a possibility
that gas comes out: this fact must not create
panic because its length is very short.
• Do not modify the appliance:
- The manufacturer does not accept any
responsability for problems arising due to.
- Incorrect usage of the appliance.
- Carelessness during usage of the appliance.
• Alterations and modifications of the appliance.
• Fitment of wrong components ( gas cartridge,
washer, gas mantle).
• The appliance works with 190 gr. butane gas
cartridge only.
• Before inserting the gas cartridge, read care-
fully the instructions pinted on the gas cartridge.
• Always use this appliance outside. Removing
and the fitting of the gas cartridge should be
done outside.
• The butane gas is dangerous and treat it carefully.
• Ensure the appliance is kept out of reach of children.
• Do not use the appliance if the washer is in
bad conditions.
• Do not use the appliance if there is any gas
leaks, if it is damaged or it is not working correctly.
• In the case of gas leaks, place the appliance
outside away from flames and other inflamma-
ble sources or materials. Find the gas leak outside,
use soapy water and never a naked flame.
• The support surface of the appliance must be
horizontal.
• The appliance must not be used near
inflammable materials.
• Ensure the knob of the gas valve is fully
closed before inserting the gas cartridge or
replacing the gas cartridge.
CLEANING OF THE APPLIANCE
Before storing the appliance ensure the gas
valve is fully closed and the appliance is
cleaned carefully. This cleaning is particulary
recommended if the appliance is not to be used
for a long period.
INSERTION OF THE GAS CARTRIDGE
• Close carefully the brass gas valve of the
appliance.
• Ensure that the pin washer is in perfect
condictions.
• Ensure the gas cartridge to be replaced is com-
pletely empty before inserting a new one. Never
change a cartridge unless the appliance is shut off.
• Twist off the bottom of the cartridge holder.
Insert the gas cartridge and twist onto the
bottom of the cartridge holder.
LIGHTING OF THE LAMP
• Remove the packing from the glass cylinder.
• Remove the handle and the glass cylinder.
• Verify that the gas mantle is inserted in the
right position, in case of absence of the mantle
insert it in the cylindrical mantle holder and
be sure that the two ends of the mantle are
located in the two spline of the mantle holder.
• Light a match and put it near the mantle, open
slowly the gas valve until the gas ignites. If the
appliance is provided with piezo ignition, press the
black button after the openning of the gas valve.
• Re assemble the glass cylinder and the handle.
• To regulate the intensity of the light, slightly
open or close the knob of the gas valve.
SHUTDOWN OF THE LAMP
• To shutdown the lamp, the control knob of the
gas valve must be fully closed.
KEEP THESE INSTRUCTIONS FOR FUTURE USE
OF THE APPLIANCE
3
Publicidad
