Checking Before The Setup; Switching The Connection Method To Wireless Lan; Checking The Router - Canon MF4890dw Guía De Configuración

Checking Before the Setup

En
Internet
Is the computer connected to the router (or the access
point) correctly by a LAN cable or wireless LAN?
For more information, see the instruction manual for the
network device you are using, or contact the networking
device manufacturer.
Has the network settings on the computer been
completed?
If the computer is not properly configured, you may not use
the wireless LAN connection even after completing the
following settings.
NOTE
• You cannot connect both the wired LAN and wireless
LAN at the same time. In addition, the machine is set
to the "Wired LAN" by default.
• When you connect to a network environment that
is not security protected, your personal information
could be disclosed to third parties. Please use
caution.
• If you connect through a LAN in the office, contact
your network administrator.
• When proceeding from "Specifying the Initial
Settings" in the Starter Guide:
Proceed to "Checking the Router" on the right side of this
page.
Switching the Connection Method to
Wireless LAN
1
Press [ ] (Menu).
2
Select <Network Settings>, and then press [OK].
3
Select <Select Wired/Wireless LAN>, and then
press [OK].
6
Wireless LAN Router
4
Select <Wireless LAN>, and then press [OK].
Select LAN
Wired LAN
Wireless LAN
5
Restart the machine for the settings to take effect.
10 Seconds
OFF

Checking the Router

Select the connection method to the wireless LAN. Select
from the following two methods depending on the router or
the access point that you are using.
There is a button.
This machine supports WPS
(Wi-Fi Protected Setup). You
can easily set up if your router
or access point has a button,
and if the following mark is on
the router.
If you are not sure whetheror not your router supports WPS,
please see the manual included in the product, or contact the
product manufacturer.
There is no button.
If there is no button on your
router/access point, you may
manually select SSID and
complete the settings. In this
case, you need to remember
SSID and network key of your
router/access point.
See "Checking SSID or Network Key for a Wireless LAN
Router/Access Point" (P.9) to learn how to find out your SSID
and network key.
To set up with WPS PIN code method, or setup
manually:
e-Manual "Setting the Machine Using WPS (PIN Code
Mode)"
e-Manual "Setting by Manually Entering SSID"
• When proceeding from "Specifying the Initial
Settings" in the Starter Guide:
Proceed to step 3 of "Setting Wireless LAN" (P.7).
ON