Dimplex Ignite 50 Serie Instrucciones De Instalación página 14

Operation
• Cycles through the different
preset light settings of the
unit, this includes different
combinations of colors of the
! NOTE: Two of the themes in
the cycle are a prism where the
unit cycles through a variety of
colors. Pressing the
cycling and holds the unit on the
preferred color, indicated by a solid
circle. When the unit is on prism,
and is cycling through the colors,
a rotating circle will be displayed.
G. Brightness
Changes the Brightness of the
lights in the unit.
the corresponding button on the
remote or the unit.
• Indicated by the second digit on
"H" (high), and "L" (low).
H. Sleep Timer
The Sleep Timer can be set to
after a preset time (from 30 minutes
to 8 hours).
timer button on the remote,
14
• The Display will display the
stops the
! NOTE: The Sleep Timer can be
cancelled at any time by pressing
the
sleep timer displays nothing.
Resetting the Temperature
Cutoff Switch
Should the heater overheat, an
automatic cut out will turn the whole
unit off and it will not come back on
without being reset. If the
on the unit is pressed, Er2 will be
displayed on the unit. It can be
reset by turning the unit off at the
main disconnect panel and waiting
5 minutes before turning the unit
back on.
continuously reset the heater, turn
the unit off at the main disconnect
panel and call technical support.
repeatedly, until the desired time
is displayed.
Once the timer has begun,
pressing the
the time remaining before the
unit turns Off.
button repeatedly until the
CAUTION: If you need to
button will display
button