Desa GA6050 Instrucciones De Instalación página 2

5. Slide the adjustable outer-hood sections into the
center section. Stop when edge of center-hood
section is even with tape (see Figure 4).
6. Place pieces of tape across adjustable outer-
hood sections and center-hood section to hold
in place.
IMPORTANT: You must remove tape before
operating your fireplace.
Edge of Center-
Hood Section
Figure 4 - Adjust Outer-Hood Section
INSTALLING HOOD TO MASONRY
FIREPLACE
Follow the instructions below that best describes
your fireplace.
Masonry With Glass Doors
1. Loosen clamps that hold glass door frame to
fireplace. Slide the mounting brackets behind
the glass door frame (see Figure 5). Place
brackets near ends of horizontal glass door
frame. Note: If frame is too tall, the bottom
of mounting bracket will not slide under lintel
(top) of fireplace. If so, cut mounting bracket
off at point "B" (see Figure 6). Slide mounting
bracket into glass door frame (see Figure 7).
2. Tighten glass door lintel clamps. This will
secure the mounting brackets.
3. Slide the hood over the mounting brackets (see
Figure 8).
Figure 5 - Placement of Mounting
Bracket
2
Masonry Without Glass Doors
1. Tape the mounting brackets near the ends of
Mounting
Bracket
2. Mark screw locations on fireplace lintel
Glass
Door
Frame
Mounting
Bracket
Masonry Fireplace without Glass Doors
www.desatech.com
A
B
Figure 6 - Mounting Bracket
Figure 8 - Hood Placement
the fireplace opening. Make sure to position
brackets as shown in Figure 9.
through the slots on bottom of each mounting
bracket.
Figure 9 - Positioning Brackets for
Bottom of
Mounting
Bracket
Lintel
Masonry
Screw
100448-01E