Duration Of Treatment; Cleaning; Storage; Replacement - Philips InfraCare PR3110/00 Manual De Instrucciones

English
12
Note: If you disconnect the device from the wall socket while the timer is activated, the timer
continues to count down and make a ticking sound.
Warning: To prevent eye damage, do not look into the light of the lamp when it is on. You
do not need to wear goggles as the InfraCare (150W) has a special light bulb that filters
out UV light.

Duration of treatment

The duration of the treatment depends on the type of treatment and the person to be treated.
Treatment of a single muscle or joint should last approximately 15 minutes. If necessary, the treatment
can be repeated several times a day. You can repeat the series of several treatments a day on several
consecutive days to get a result. If there is no improvement after 6-8 treatments, stop using the device
and consult your doctor. For chronic problems, the device can be used for longer periods of time.
Follow the instructions for safe use (see 'Warning').
Warning: Always consult your doctor in case of doubt.

Cleaning

Note: Never use scouring pads, abrasive cleaning agents or aggressive liquids such as
petrol or acetone to clean the device.
1 Unplug the device and let the lamp cool down for approx. 15 minutes before you clean the device.
2 Clean the device and the pedestal with a moist cloth.
Warning: Do not let water run into the device or spill water onto the device.

Storage

Note: Do not let the cord come into contact with the lamp when it is hot.
1 Unplug the device and let the lamp cool down for approx. 15 minutes before you store it.
2 Roll up the mains cord and wrap the Velcro around it (Fig. 9).
3 Store the device in a dry place.

Replacement

Lamp
The effectiveness of the lamp does not diminish in the course of time.
Warning: Only use a Philips PAR38 IR 150W E27 230V lamp to replace the lamp of the
device. Use of any other lamp may be hazardous.
Note: If the lamp stops working, contact the Consumer Care Center in your country.