HP Autozubehor HP Powerpack 20976 Manual Del Usuario página 13

2. JUMP START button: press it twice to turn on 12V startup output, then
press it for 6 seconds to turn on 24 V startup output, and press it to turn
off 12V/24V output.
Notes:
1. Make sure that the customized working voltage of the vehicle or load is
12V or 24V before using the clamp (incorrect working voltage may
damage the equipment);
2. Select the corresponding output voltage before using the clamp, and
then connect the clamp to the vehicle or load (the positive and negative
poles shall not be connected inversely);
instructions:
1. The flash of 12V/24V indicator indicates that the emergency power
supply is undergoing self-test; After the buzzer makes a short sound,
the indicator light is on, indicating that the starting output can start the
vehicle normally.
2. if the 12V/24V indicator is flashing and the buzzer is quick and short, it
means that the starting power supply temperature is too high, it should
be stopped immediately and put in the ventilation area until the normal
temperature is restored.
3. if the 12V/24V indicator light is flashing and the buzzer is slow and
short, it means that the starting power supply voltage is too low or
reverse charge occurs, it should be stopped immediately and charged
in time if the power is low.
4. if the 12V/24V indicator light is flashing and the buzzer is one long or
two short, it means that the red/black clip of starting power supply has
short circuit. The connection of red/black clip should be broken
immediately;
For Jump Start Of 12V or 24V vehicle
1. First, ensure that the power indicator is at least three cells; Press two
seconds long to close all host output. Then insert the 12V or 24V switch
into the host to ensure full contact with the host and insert the clamp.
3