Feature Identification; Troubleshooting - Tripp-Lite 230V INT Serie El Manual Del Propietario

Feature Identification

1
1
Lighted ON/OFF Switch: move to ON ("I") position to power connected equipment; switch will
illuminate. Move to OFF ("O") position to stop powering connected equipment.
2
AC Outlet: accepts 230V AC equipment you would normally plug into a wall outlet.
3
DC Fuse(s) (externally mounted): protect vehicle battery from damaging overload. If fuse
blows, replace with standard automotive fuse of equal amperage. CAUTION: installing non-
rated fuses could cause equipment damage and void your warranty.
4
Vehicle Lighter/Accessory Plug: connects to a standard 12V DC vehicle lighter/accessory
outlet.
5 Cooling Fan: maintains internal cooling.
6 Ultra-Compact, Lightweight Metal Case
Low Battery Alarm (internal, not shown): detects low voltage and shuts down Inverter to preserve
vehicle battery. If alarm sounds, turn Inverter OFF and run engine to recharge battery.
Overload Alarm (internal, not shown): detects wattage overload on Inverter outlets and shuts
down Inverter as a protective measure. If alarm sounds, turn Inverter OFF and reduce wattage load
(by unplugging high-wattage devices).

Troubleshooting

Please check the following before sending the Inverter in for service:
Symptom
Alarm sounds.
Inverter does not turn
ON when power switch
is turned ON
Inverter is unable
to power connected
equipment.
Connected equipment
experiences audio/
video distortion.
19-04-289-932610.indb 3
6
4
Problem
Low battery voltage
(<10.5 V).
Output overload.
Automatic Inverter
shutdown due to low
battery voltage (<10V).
Automatic Inverter
shutdown due to output
overload.
Blown fuse.
Battery running low. Low
battery voltage reduces
Inverter power output.
Connected equipment
load exceeds Inverter's
maximum continuous
output power.
Loose connections.
Audio/video interference.
3
2
Correction
Turn Inverter OFF and run engine to recharge vehicle battery.
Turn Inverter OFF and remove overload by unplugging high-
wattage devices. Load should not exceed your Inverter's
maximum continuous output power (see Specifications).
Turn Inverter OFF and run engine to recharge vehicle battery
Turn Inverter OFF and remove overload by unplugging high-
wattage devices. Load should not exceed your Inverter's
maximum continuous output power (see Specifications).
Replace fuse with standard automotive fuse of identical
amperage (see Specifications).
Turn Inverter OFF and run engine to recharge vehicle battery.
Turn Inverter OFF and remove overload by unplugging high-
wattage devices. Load should not exceed your Inverter's
maximum continuous output power (see Specifications)
Check and secure all connections.
Reposition equipment antennas and Inverter.
3
5
5/14/2019 1:37:16 PM