Roland KSC-40 Manual De Instrucciones página 2

Installing the Piano on the Stand
6.
Align the protruding screws (one each at right and left) on
the bottom of the piano with the openings in the metal
fittings on the side board, then slide the piano forward until
the screws are held in place.
* When handling the piano, firmly grasp it. Be careful, so you do not get your
fingers pinched.
7.
Fasten the piano to the stand with the screw "b" (M5 x
20mm).
Connecting the Pedal and Power Cords
8.
Connect the pedal cord to the Pedal connector.
9.
Connect the power cord to the AC Inlet on the piano, then
plug the other end into AC Outlet.
10. Secure the pedal cord and power cord in place with the
coated clip at the lower rear of the piano.
8
Adjusting the Adjuster
11. Lower the adjuster at the bottom of the pedal board (by
rotating it), so that the adjuster touches the floor. If you
have the piano placed on a carpet, lower it until it pushes
into the carpet.
When Moving the Piano
Disconnect the power cord , cables, and raise the stand's
adjuster. Then lift the piano while keeping it level, and
move it with care, so that you do not drop it on your feet,
or get your hands caught.
6
7
Please don't get your
fingers pinched.
Screw "b"
Coated clip
9
Adjuster
11
2