Search Code (Automatic Search); Code Search Under Brand Name; Identifying The Code; Learning Function - Medion ND 4689 Manual De Instrucciones

Univ-FB MD 4689 ML.book Seite 17 Mittwoch, 5. Juli 2006 9:46 09
There are a huge number of different code numbers, but in same cases it is possible
that only the most common functions are available. With certain special models it
might be that the described operating method may not function.
The search starts after the last 3 digits registered code.

SEARCH CODE (AUTOMATIC SEARCH)

You can also use the automatic search. Please proceed as follow:
1. Switch on manually the appliance you wish to control (TV, VCR etc...)
2. Press and hold the "SET" key for 3 sec. about, until the LED indicator lights
continuously.
3. Release the "SET" key.
4. Press and release the mode key of the device you wish to control (TV, VCR,
DVD, CD, SAT, AUX).
5. Point the remote control in the direction of the appliance you wish to control
and press and release "CHAN +" key. The remote control starts the search
and sends a code every second. Each time a code is sent, the LED turns on.
6. As soon as the appliance reacts to the remote control, press the "OK" button.
If you did not press OK touch in time, you can step back by pressing CHAN- as
many times as necessary, to come back to the code which made the device react.
If you wish to slow down the search process (one code each 3 sec. instead of each
1 sec.), press and release CHAN+ twice (see step 5). By this way, you will have
more time to confirm a code, but the search process will be longer.

CODE SEARCH UNDER BRAND NAME

This feature offers the possibility to launch the automatic search by brand. You will
find the brand code in the code table, under "search code under brand name".
Proceed as follows:
1. Switch on manually the appliance you wish to control (TV, VCR etc...)
2. Press and hold the "SET" key for 3 sec. about, until the LED indicator lights
continuously.
3. Release the "SET" key.
4. Press and release the mode key of the device you wish to control (TV, VCR,
DVD, CD, SAT, AUX). Enter the one digit code of the brand code table "Search
under brand name".
5. Press repeatedly "POWER" or "CHAN+" or "PLAY", until the appliance reacts
normally. Proceed quickly in order to prevent the launching of the automatic
search.
6. Briefly press "OK" button to stock the code.
When all the codes have been sent, the LED blinks during 3 sec.

IDENTIFYING THE CODE

1. Press and hold the "SET" key for 3 sec. about, until the LED indicator lights
continuously.
2. Release the "SET" key.
3. Press and release the mode key of the device you wish to control (TV, VCR,
DVD, CD, SAT, AUX).The LED blinks.
4. Press again "SET". The LED blinks again.
5. To identify the first digit press each number button from 0 - 9 until the LED
turns 0ff. At this step, the number you pressed is the first digit of the code. To
find the 2nd and 3rd digit, repeat the above process.
6. When the third digit has been found the LED will go off.
7. The identification of the code is finished.

LEARNING FUNCTION

The MD4689 remote control can stock certain functions which are not included in
the entered code, even appliance codes which are not in the code list. You need
your original remote control for this. To avoid mistakes, please follow the below
advice.
EN-17