Transmitter; Preparing The Transmitter; Transmitter Controls - Merlin Tracer 180 Manual Del Usuario

Transmitter

Your Merlin Transmitter is an advanced controller designed for the beginner to be easy to use and tune. You will need to follow the steps below to
ensure you prepare the controller correctly for use and understand the adjustment possibilities available.

Preparing the transmitter

Transmitter Controls

2
1
5
10
Binding the transmitter to the model.
1. Hold down the channel setup button in the top right hand corner of the transmitter and then turn the transmitter on. The power lights on the
transmitter will light fully and then dim. At this point release the channel setup button and the power lights on the transmitter will start
flashing.
2. Turn on the model. The lights on the front of the model should flash rapidly before becoming solid, along with the power lights on the
transmitter. This means the transmitter is now bound to the model. You should only need to carry out the binding process once when the
model is new, unless you change the transmitter or receiver in the model.
Open the battery holding tray to
expose the empty battery slots.
Insert 4 AA batteries into the
marked spaces. Please note the
correct direction of the batteries.
Incorrect battery insertion could
lead to damage.
1
4
8
3
1
9
1. Aerial
2. Throttle Trim
3. Cyclic L/R Trim
4. Cyclic F/B Trim
5. Throttle Stick
6
6. Cyclic Control Stick
7. Power Switch
8. Battery level indicator
9. Channel Setup Button
10. Rudder Trim
11. Rate Switch
12. Training Switch
3
7
Make sure the aerial on the
transmitter is fully upright before
switching the transmitter on.