SEVERIN ST7300 Instrucciones De Uso página 9

Baby bottle sterilizer
G
Dear Customer,
Before using the appliance please read the
following instructions carefully.
Connection to the mains supply
The baby bottle sterilizer should only be
connected to an earthed socket installed in
accordance with the regulations. Make sure
that the supply voltage corresponds with the
voltage marked on the rating label.
This product complies with EEC Directives
89/336/EEC and 73/23/EEC.
Familiarisation
1. Rating label
2. Base unit
3. Power cord
4. Main switch
5. Indicator lamp
6. Heating element
7. Bottle holder
8. Adaptor ring
9. Holder insert
10. Lid
11. Steam outlet
Important safety instructions
The surface of the housing as well as the
G
inserts heat up during operation.
Beware of hot steam escaping from the
G
unit. Do not open the lid while the unit is
switched on.
Do not allow the appliance to operate
G
without supervision.
Do not allow the power cord to come
G
into contact with any hot parts of the
appliance and do not coil the power cord
around the unit.
Always remove the plug from the wall
G
socket
- after use, and also
- in case of any malfunction
- before cleaning the appliance.
Do not operate the sterilizer if the
G
appliance or the power cord show any
signs of damage.
No responsibility is accepted if damage
G
results from improper use, or if these
instructions are not complied with.
This appliance is intended for domestic
G
use only and not for commercial
applications.
In order to comply with safety
G
regulations and to avoid hazards, repairs
of electrical appliances must be carried
out by qualified personnel, including the
replacement of the power cord. If repairs
are needed, please send the appliance to
one of our customer service departments.
The address can be found in the
appendix to this manual.
Before using for the first time
Before the appliance is used for the first
time, all parts must be thoroughly cleaned as
described in the section General Care and
Cleaning.
Main switch
The baby bottle sterilizer is activated by the
main switch. The unit switches off
automatically and cannot be switched off
manually. Before inserting the plug into a
suitable wall socket, ensure that the unit is
filled and ready for operation, since it may
already be switched on.
Operation
- Place the unit on a level and waterproof
surface.
- Round the heating area, there is a deep
recess in the base unit. This recess must
be filled with approx. 100 ml cold fresh
water without any additional agents or
additives.
- Place the bottle holder inside the unit.
The bottles are placed (without their
tops) onto the bottle holder with the
openings facing downwards.
Before sterilizing can take place, the
G
bottles must be thoroughly cleaned.
- When sterilizing longer bottles, the