Assembly Instructions - Kobalt SGY-AIR213 Manual Del Usuario

ASSEMBLY INSTRUCTIONS

1. Remove the air inlet protective cap from the air inlet (H)
(See Figure 1).
2. Mount a male plug (not included) by hand into the air inlet
(H) (See Figure 2).
NOTE Use threaded sealant tape (not included) on the
threading of the male plug. Once sealant tape is properly in
place, tighten male plug turning clockwise with a wrench (not
included) for air tight connection. DO NOT OVERTIGHTEN.
3. Place 2 - 3 drops of air tool oil (not included) into the male
plug before each use (See Figure 3).
1
2
3
6