Pleasant Hearth 28-62-73 Instrucciones De Ensamble página 3

Carefully remove all pieces from carton and
Step 1
make sure that you have all parts listed (refer
to parts list on page 1).
If you are missing parts, please call GHP
customer service at 1-877-447-4768.
1. Lay middle panel (3) on a clean, non-abrasive
surface with center front panel (2) on top and
slightly overlapping. Insert 2 Allen bolts (B)
through flat washers (C), through pre-drilled
holes in center front panel (2), and into pre-
drilled holes in middle panel (3). Tighten
securely with Allen wrench (D).
Step 2
2. Insert 4 wood dowels (A) into pre-drilled
holes in edges of middle/center front panel
assembly. Slip one end panel (4) over dowels
on the left side. Slip second end panel (4) over
dowels on right side. NOTE: End panels are
interchangeable. Make sure both panels are
snug, then secure with flat washers (C) and
Allen bolts (B) in pre-drilled holes as shown.
Tighten with Allen wrench (D).
Step 3
3. Insert 2 wood dowels (A) into pre-drilled
holes in top edge of right/left side panels (5).
Slip right side panel (5) into pre-drilled hole on
left bottom edge of middle/center front panel
assembly. Slip left side panel (5) into pre-
drilled hole on right bottom edge of middle/cen-
ter front panel assembly. NOTE: Side panels
are interchangeable. Make sure both panels
are snug, then secure with flat washers (C) and
Allen bolts (B) in pre-drilled holes as shown.
Tighten with Allen wrench (D.
2