Installation Instructions; Remove Shipping Materials; Remove Shipping Base And Packing Ring; Connect Drain Hose - Kenmore 110.2810 Serie Instrucciones De Instalación

INSTALLATION
INSTRUCTIONS
Before you start: remove shipping materials.
It is necessary to remove all shipping materials for proper
operation and to avoid excessive noise from washer.
NOTE: To avoid floor damage during installation, set the washer
onto cardboard before moving across the floor.
IMPORTANT:
Be sure the foam shipping base has been removed from the
■
bottom of the washer as directed in the "Remove Shipping
Base and Packing Ring" section.
If foam shipping base has not been removed, be sure lid is
■
secured with tape before laying washer on its back.
Removing the foam shipping base is necessary for proper
■
operation.
REMOVE SHIPPING BASE
AND PACKING RING
1�

Remove shipping base and packing ring

Place cardboard supports from shipping carton on floor behind
washer for support. Secure the lid with tape. Using two or more
people, tip the washer onto its back and place on cardboard
supports. Remove foam shipping base. Then, set washer back
upright, and remove the tape from the lid so that you can open
the lid and remove the foam packing ring from the washer tub.
NOTE: Keep foam packing ring in case you need to move
the washer in the future.

CONNECT DRAIN HOSE

IMPORTANT: Proper connection of the drain hose helps to avoid
water leakage and damage to your floors. The drain hose is
connected to your washer and is stored inside the washer cabinet.
1�
Remove drain hose from washer cabinet
Gently pull hose out of back of washer cabinet from top until
end emerges.
IMPORTANT: Do not force excess drain hose back into rear of
washer.
2�
Connect drain hose form
For a laundry tub or standpipe drain, connect the drain hose
form. For a floor drain, do not install drain hose form. You may
need alternate parts with separate directions. See "Tools and
Parts" to determine what you may need.
Feed hose into one end of form. Bend hose and feed through
other side, anchoring form on smooth sections of hose. The
hose must extend 4.5" (114 mm) beyond the form.
7