Brentwood Appliances BLEND-TO-GO JB-195 Instrucciones De Operación Y Seguridad página 6

1. Place the Motor Base on a clean, flat surface.
2. Fill your clean Blend-To-Go Cup with your favorite ingredients, leaving
at least a 1 inch rim and do not fill past the Max line. This will allow the
Blade Assembly to be inserted without overfilling the Cup.
CAUTION: Do not overfill the product or operate it when empty.
3. Place the Blade Assembly and tighten by turning clockwise until it
completely secured.
4. Invert the Blend-To-Go and insert the Blade collar into the motor base
until the slots are in place.
5. Turn the Cup clockwise to lock it in place. Connect Plug to the nearest
120 V AC electrical outlet.
6. Pulse your beverage to the consistency of your preference.
CAUTION: Pulse no longer than 1 minute straight. Allow motor to rest 3
minutes before continuing. 1 minute can overheat the motor.
Attention: First use may cause a slight odor or small smoking upon
heating, it is normal. This is a result of the heating element chemical
reaction. It quickly goes away.
7. When you have finished blending, disconnect the appliance from the
outlet and turn the blending cup counter clockwise to remove from the
base.
8. Lift and position the cup right side up and carefully remove the Blade
assembly and add the Travel Lid.
9. Clean and store the blade assembly away from reach of children.
Cleaning Your Blend-To-Go Blender:
WARNING: Always unplug the product and allow it to cool before cleaning
or storing it.
NOTICE: Never immerse the motor base, plug or cord in water or any other
liquid.

It is recommended to rinse parts immediately after use to make
cleaning easier.

Handle blades with extreme caution. You may use a small nylon
bristle brush to remove food that has adhered to the Blade
assembly.
6