MAC Audio MAXIMUS 2.13 Manual Del Propietario / Documento De Garantía página 9

GB
POSITIONING AND SECURING THE SPEAKER SYSTEM
Use the mounting positions provided in your vehicle. If the speakers do not fit, they can
be placed in the rear window shelf.
Make sure that the subwoofer is secured in such a way that it cannot slip or slide.
Use the screws provided for this purpose. Damage resulting from sudden
changes in speed (e.g. hard braking) is not covered under the terms of our
guarantee.
CONNECTING TO THE RADIO / AMPLIFIER (FIG. 1)
The speaker system should preferably be connected to an external power amplifier.
This can provide the required electrical power and create corresponding dynamic
reserves. The relevant instructions also contain the customized connection diagram for
the operation of a speaker system.
Should you not have a power amplifier, the speakers can also be connected directly
to the radio. The relevant operating instructions also contain the connection diagram
for this situation.
Please note that only limited dynamic reserves will be available in this case.
Excessively low outputs combined with high distortions can destroy your speakers.
BI-WIRING / BI-AMPING
The Maximus component systems are designed for conventional as well as bi-amping
and bi-wiring. If so desired, the mid-tweeters and mid-woofers can therefore be
controlled separately from each other. In this case, the bi-amping switch inside the
external crossover must be set at "On". Both inputs must then be connected to the
respective amplifiers.
The factory setting for the bi-amping switch is "Off", i.e. for conventional operation.
9