Black and Decker FireStorm FS6000JSL Manual De Instrucciones página 8

90501323 FS6000JSL
VARIABLE SPEED CONTROL
- Set the variable speed control knob (3) to the required speed range. Use a high speed
for wood, medium speed for aluminum and PVC and low speed for metals other then
aluminum.
FINISH CONTROL SYSTEM ORBITAL SELECTOR
- For fast and efficient straight cuts in wood, set the selector (13) to the number "2".
- For accurate straight and curve cutting and a smooth surface finish, set the turbo
selector (13) to the number "1".
- Set turbo orbital action selector (13) to the number "0" position for non-orbital cutting/
metal cutting.
SWITCHING ON AND OFF
- To switch the tool on, press the switch (1). The tool speed depends on the variable speed
control knob (3) setting.
- For continuous operation, press the lock-on button (2) and release the switch.
- To switch the tool off, release the switch. To switch the tool off, when in continuous
operation, press the switch once more and release it.
Operating the Laser
Your saw is equipped with a laser which is turned on and off separately from the jig saw.
WARNING: NEVER aim the beam at a workpiece with a reflective surface. Bright
shiny reflective sheet steel or similar reflective surfaces are not recommended for laser
use. Reflective surfaces could direct the beam back toward the operator.
DANGER: LASER RADIATION. AVOID DIRECT EYE EXPOSURE. Do not stare into
the laser light source. Never aim light at another person or object other than the
workpiece. Laser light can damage your eyes.
WARNING: DO NOT use tinted glasses to enhance the laser light. Tinted glasses
will reduce overall vision for the application and interfere with the normal operation of the
tool.
INSTALLING THE BATTERIES (FIG. E)
Detach the laser from the jig saw by removing the screw (20) and pulling laser (10)
forward. Insert 2 fresh 1.5 volt AAA batteries making sure to match (+) and (-) terminals
correctly. Reattach the laser.
WARNING: Batteries can explode, or leak, and can cause injury or fire. To reduce
this risk:
• Carefully follow all instructions and warnings on the battery label and package.
• Always insert batteries correctly with regard to polarity (+ and -), marked on the battery
and the equipment.
• Do not short battery terminals.
• Do not charge batteries.
• Do not mix old and new batteries. Replace all of them at the same time with new batteries
of the same brand and type.
• Remove dead batteries immediately and dispose of per local codes.
• Do not dispose of batteries in fire.
• Keep batteries out of reach of children.
• Remove batteries if the device will not be used for several months.
"Transporting batteries can possibly cause fires if the battery terminals inadvertently
come in contact with conductive materials such as keys, coins, hand tools and the like.
The US Department of Transportation Hazardous Material Regulations (HMR) actually
prohibit transporting batteries in commerce or on airplanes (i.e. packed in suitcases
and carryon luggage) UNLESS they are properly protected from short circuits. So
when transporting individual batteries, make sure that the battery terminals are
protected and well insulated from materials that could contact them and cause a short
circuit."
SWITCHING THE LASER ON AND OFF (FIG. E)
To turn the laser on, press in on the on/off button (21). To turn the laser off, press the
button a second time. The laser button is "on" when subflush to the housing, and "off"
when the laser button is flush.
4/5/06 11:06 AM Page 8
8