TopCold FS80CP Manual De Instruccion página 3

1. There must be at least 15 cm free space above the cooler in order for the cooling
system to work satisfactorily.
2. Since the cooler takes up more room width wise when the door is opened, the door
must either be placed free of the wall or there should be enough space of at least
1.5 cm at the hinge side.
3. There must be sufficient room at the hinge side to clean and replace the wire
shelves or wooden shelves
Electrical Connections
Your cooler operates on 230V/50Hz.
The plug must be earthed. Use a 10A fuse. The socket must be out of reach of children. If
the plug does not fit to the socket, use an adaptor.
If you need to replace the plugged cord, use earthed plug. This installation of a new
suitable plug may proceed by appointed service agent or skilled electrician.
The main electrical connections must be done by skilled electricians.
If the supply cord is damaged it should be replaced by the manufacturer or appointed
service agent in order to avoid hazard.
Control Panel
The control panel is located at the top of the cooler. The control panel has a green lamp
and a light switch. The green lamp is on, when the cooler is plugged in. The light switch
controls on/off function of the fluorescent lamp.
The thermostat adjustment button controls the temperature in the cooler. Turn the button
to clockwise to decrease the temperature and if turned to anti-clockwise it stops. For wine
coolers turn the button to anti-clockwise to decrease the temperature and if turned to
clockwise it stops. However, the cooler is still connected and the green light is still on.
Temperature adjustment of wine cooler – see separate section.
Lighting
The models without canopy are equipped with interior light and the models with canopy
are equipped with interior light and canopy light.
If any problem occurs at the fluorescent tubes please call the service men.