Tabla de contenido
Publicidad
Operate Washing Machine
- Drum Clean
This cycle is specially set in this machine to clean the drum and tube. It applies 90 C
high temperature sterilization . Do not add clothes during this cycle. Add a measure of
bleach to Improve cleaning results. Perform this procedure regularly according to your
needs.
The customer can use this procedure regularly according to the need.
- Bubble Removal Function
Bubble Check Function: Redundant bubbles will occur when there is excessive detergent,
which will affect Wash and Rinse effects. The machine will check automatically and one
bubble removal procedure will be added automatically to remove bubbles when excessive
bubbles are found. It will also remind the user to use less detergent during the next
similar washes.
Table of Washing Procedures
Load(kg)
7.0
2.0
7.0
Cotton Intensive
7.0
0
7.0
3.5
2.0
7.0
Energy test program cotton
:
intensive
60 C,the washing time is 160 minutes.
● Means must
○ Means optional
Means not necessary
Notes: The parameters in this table are only for user's reference. The actual parameters may vary.
Default
Default Time
Temp.( C)
(Min)
1000
7.0/8.0kg
7.0/8.0kg
Cold
25
1000
40
120
1000
N/A
20
1000
90
145
500
40
1000
120
40
700
120
40
105
500
1000
40
125
P.16
Maintenance
Before your maintenance starts, please do pull out the power plug or disconnect power
and close the tap.
- Solvents are forbidden to avoid that the washing machine is damaged, and toxic gases
are generated or exploded.
- Never use water to sprinkle and wash the washing machine.
- It is forbidden to use detergents containing PCMX to clean the washing machine.
Cleaning and Maintenance of Washing Machine Cabinet
Proper maintenance on the washing machine can extend its working life. The surface can
be cleaned with diluted non-abrasive neutral detergents when necessary. If there is any
water overflow, use the wet cloth to wipe it off immediately. No sharp items are allowed to
strike the cabinet.
Notes: Do not use any solvents or abrasive cleaners.
Clean Internal Drum
The rusts left inside the drum by the metal articles shall be removed immediately with
chlorine-free detergents.
Never use steel wool.
Dispose a Frozen Washing Machine
When the temperature drops below zero and your washing machine gets frozen, you may:
1.Disconnect the power supply for the washing machine.
2.Wash the tap with warm water to loosen inlet pipe.
3.Take down inlet pipe and immerse it in warm water.
4.Pour warm water into washing drum and wait for 10 minutes.
5.Reconnect inlet pipe to the tap and check whether inlet and outlet are working normally.
Notes: when the washing machine is reused, make sure the ambient temperature is above 0 C
Anti-freeze
If your washing machine is located in the room where it can get frozen easily, please drain
the remaining water inside drain pipe and inlet pipe thoroughly.
Remove the remaining water in inlet pipe:
1.Close the tap.
2.Screw off the inlet pipe from tap and put its end into a container.
3.Start up any procedure except single Wash or Drain .
Water will be drained out of inlet pipe if any
in about 40 seconds.
4.Reconnect the inlet pipe to tap.
Remove the remaining water in drain pump
Just need wait a few minutes, the water will automatically
outflow.
T
o avoid burning, it shall be done after the hot water
inside the machine cools down.
P.17
Publicidad
Capítulos
Tabla de contenido
