SILENT LED I
UGR<19
600
DEGREE OF PROTECTION
Degree of waterlightness luminary
Degree of waterlightness installed
WARNING
BEFORE INSTALLING THIS PRODUCT, PLEASE READ THE
INSTRUCTIONS CAREFULLY AND STORE THEM IN A
SAFE PLACE.
THE INSTALLATION SHOULD BE CARRIED OUT BY
TRAINED STAFF.
INCORRECT HANDLING OF THE PARTS OR THE
LIGHT FIXTURE ITSELF MAY IMPAIR THE PROPER
PERFORMANCE OF THIS PRODUCT. IN THIS CASE,
THE MANUFACTURER GUARANTEE SHALL BE DEEMED
VOID.
THE MANUFACTURER GUARANTEE SHALL BE DEEMED
VOID: IF THE INSTALLATION IS NOT PERFORMED IN
ACCORDANCE WITH THE SPANISH LOW VOLTAGE
ELECTROTECHNICAL REGULATION 2002 (REBT 2002).
THE APPLICATION OF IBC BT09-4 OF REBT (INSTALLATION
OF LINE AND LIGHT FIXTURE SURGE PROTECTORS) IS
ESSENTIAL FOR INDUSTRIAL AND PUBLIC LIGHTING
INSTALLATIONS. THE GUARANTEE DOES NOT COVER
AGAINST DAMAGES CAUSED BY SURGES IN LIGHT
FIXTURES WITHOUT SURGE PROTECTORS INSTALLED.
ATTENTION!!!
OBSERVE
PRECAUTIONS
HANDLING
SENSITIVE DEVICES.
1/4
1/4
9
IP20
IP40
FOR
ELECTROSTATIC
300
PRECAUTIONS:
• Read this manual before installing the product, if in doubt consult qualified
personnel
• If the product or diffuser is damaged, replace it immediately with a new
one
• Disconnect the power before installing the product
• Keep the product out of the reach of young children.
• Do not handle the product while it is in operation and let it cool before
touching it with your hands.
• Do not install the product where there are heat sources or moisture con-
centrations.
• This device must be used with the specified power supply
• Not valid for use in bathrooms.
• Only for interior use.
• LED lamp not replaceable.
CONNECTION INSTRUCTIONS:
1. Disconnect the electrical current.
2. Connect power cords. Make sure the connection is correct and there is
no bare copper wire.
3. Connect the power and regulation cables according to the wiring dia-
grams. Caution: Ensure correct polarity.
4. Mount the appliance and the power supply unit in the correct position,
respectively.
5. Reconnect the power supply.
9
600