Using The Appliance - Moulinex FRUTELIA Manual De Instrucciones

BEFORE FIRST USE
• We recommend that you wash all the removable parts (A, B,C, D, E, G, L, M) in
warm soapy water (see paragraph "Cleaning"). Rinse and dry them carefully.
• Unpack the appliance and place it on a solid, stable work surface.
• Ensure that all packaging has been removed before starting the appliance.

USING THE APPLIANCE

• Place the juice collector (E) on the body of the appliance (see Fig. 1).
• Place the sieve (D) in the juice collector (E). Ensure that the sieve is properly
clipped onto the drive shaft (J). You can hear an audible click when the
sieve is positioned correctly (see Fig. 2).
• Fit the pulp collector (G) on the rear of the appliance (see Fig. 3).
• Fit the cover (C) on the appliance, spout to the rear (see Fig. 4).
• Push the safety clamp (H) to the rear until it locks into place. You will hear an
audible "click" (see Fig. 5).
• Slide the pusher (A) into the feed tube (B) aligning the groove on the pusher
with the small ridge in the feed tube.
• The juice jug cover (L) has a foam separator that keeps the foam in the jug
(M) when you pour the juice into a glass. If you do not want to separate the
foam, remove the cover.
• Place the juice jug (M) under the pouring spout in front of the appliance
(see Fig. 6).
• Plug in the appliance.
• To start the appliance, use the control switch (I).
• Insert the fruits or vegetables through the feed tube (B).
• The fruits and vegetables must be inserted only while the motor is running.
• Do not press too hard on the pusher (A). Do not use any other utensil. NEVER
push with your fingers.
• When you have finished, stop the appliance by turning the control switch (I)
to 0 and wait until the sieve (D) stops completely.
• When the pulp collector (G) is full, or the juice flow slows down, empty the
pulp collector and clean the sieve and the cover.
• Remove the "juice collector + filter" assembly by pulling vertically using
both hands (see Fig. 7 and 8).
8