Publicidad
Idiomas disponibles
Idiomas disponibles
m
CAUTION! Do not take the screw
completely out; just loosen it until the control
lever
can be easily taken off.
17
Take off the control lever
Loosen the cartridge covering ring
hand. Then, screw off the cartridge retaining
ring
by using a pipe wrench.
21
Now pull the setting ring
help of a screwdriver.
Note: Do not remove the cartridge
Place the setting ring
position (see Fig. I).
Tighten the cartridge retaining ring
the tap body
again by using a pipe
16
wrench. Then, tighten the cartridge covering
ring
by hand.
20
Place the control lever
body
. Tighten the locking screw
16
turning it clockwise using a hexagonal key.
Press the small plastic cover
opening.
Turn on the main water supply and check the
temperature limiter.
˜ Operation
˜ Bringing into use
Note: If the fitting has not been used for a long
period flush the pipes through thoroughly in order
to avoid stagnation and build-up of residues in
the drinking water supply.
Open the main water supply.
Lift the control lever
right or left in order to regulate the speed or
temperature of the water flow.
Check operation of the mixer. For this
purpose move the control lever
possible positions. Please regularly check all
connections to ensure that they are tight.
12 GB/IE
.
17
by
20
upwards with the
15
.
22
in the desired
15
onto
21
back on to the tap
17
by
19
into the
18
and swing it to the
17
in all
17
˜ Water-saving function
The cartridge
in this tap has an water
22
saving function. This feature limits the water
flow through the tap. This means you can
save up to 50 % water (see Fig. J)
Lift the lever
until you notice a slight
17
resistance. This resistance will cause a stop
in case of partial opening and will therefore
simply limit the flow of water.
If you want to increase the flow rate, exert
slight pressure on the lever
overcome the resistance.
˜ Energy-saving function
The cartridge
in this tap has an energy
22
saving function.
Only cold water will flow out when the lever
is set to the middle position, and thus
17
reduces the energy consumption (see Fig. K).
˜ Maintenance and cleaning
˜ Tap care and cleaning
Please note that sanitary fittings require special
care and attention. Therefore you should follow
the following advice:
Never use corrosive or alcohol-based
materials for cleaning, as these could
damage the product.
Clean your fittings with clean water, mild
detergent and a soft cloth or leather only.
Screw out the aerator
and remove lime deposits or foreign bodies.
Non-observance of the above care advice can
be expected to result in damage to the surface
of the fittings. In this event your rights under the
warranty may be invalidated.
until you
17
at regular intervals
2
Publicidad
