Publicidad
extending your gate
fig. 6
7
7
82cm - 89cm
89cm - 96cm
(See fig. 6)
Measure your doorway. The diagram shows you how many extensions you will need to fit your
gate within the desired width.
(See fig. 7)
To fit your extension system (available separately) first remove the two screw adjusters (B)
from the side of your gate. Prise the plastic bungs (G) from each corner of your gate from
below using a flat screwdriver. Push the extension into place and press the plastic bungs
back into your extension. Slide the screw adjusters back into place and fit your safety gate
as instructed in the 'fixing your gate and fixing cups' section. If a second or third extension
is required, repeat this procedure on the other side of your gate. In the UK, extensions can
be purchased by calling 0871 702 1000; Non-UK customers, please contact your retailer.
Note: fixing cups must still be used when using an extension.
fig. 7
5
7
7
7
7
77
77
96cm - 103cm
103cm - 110cm
G
C
B
G
using your mothercare safety gate
(See fig. 8)
To open your gate: Press the two buttons and lift the lever in one action
To close your gate: Align the handle with the frame and lower the lever until it clicks into
place. The gate stop at the bottom of your gate may be set to restrict the opening of the
gate to one direction only. It also acts as a further locking device which should be used,
especially on stairs.
fig. 8
Check the fitting of your gate daily to ensure it remains securely fixed and that all
attachments and locking devices are operating correctly.
6
Publicidad
