Publicidad
1200 W – 230V/50Hz or 110V/60Hz
INSTRUCTIONS
1. Use: Your Soldamatic is suitable for temperatures between -10º C and 45º C, with a
relative humidity of 45% to 95%.
2. Welding technical information:
Ø Exterior
(mm)
16
20
25
32
40
50
63
75*
90*
110*
*
This sockets are the ones supplied in the set.
Note: The listed heating times should be increased by 50% for temperatures below 5º C.
The heating sockets are screwed to the head support with the supplied allen screws.
The welder is screwed to the red base plate with the supplied Philips screws.
The red and green lights turn on automatically when the welder is plugged in (always
use an earthed power supply). Wait until the red light turns off to start any welding
process.
Keep the appliance away from water.
Avoid direct contact with hot parts.
CHECKING
1. Before performing any welding operation, check parts compatibility.
2. Inspect pipe and parts.
3. For pipe cutting operations, always use specially designed plastic pipecutters. Unevenly
cut material will not provide a quality weld.
4. Do not turn the pipe or attached parts during the heating and welding process.
5. Welded piping should be tested before use.
SOLDAMATIC-1200
Ø Interior
Socket heating
(mm)
2,7
3,4
4,2
5,4
6,7
8,4
10,5
10,4
12,5
15,2
Pipe heating
(s)
(s)
5
4
5
4
7
4
8
4
12
6
18
6
24
6
30
8
40
8
50
10
Pipe cooling
(mins)
3
3
3
4
4
5
6
8
8
8
Publicidad
