Maintenance And Cleaning; Metal Grease-Trapping Filters - Bertazzoni KIN 36 PRO X Manual De Instrucciones

Ocultar thumbs Ver también para KIN 36 PRO X:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

I
LIGHTING
SPOTLIGHT
How to replace a square halogen light:
a) Check that the equipment is disconnected from the power supply.
b) Open the panel completely till 90° (see figure) pressing the PUSH button.
c) Replace the lamp with a similar one (halogen, max 20W, 12 Volt, G4 connection).
d) Close the panel. If the panel does not close correctly repeat the operation at point b.
L

MAINTENANCE AND CLEANING

Constant maintenance ensures the correct operation and efficiency of the appli-
ance over time. Special attention should be paid to the metal grease-trapping
filters and the charcoal filters. Frequent cleaning of the filters and their supports
will ensure that fats and grease do not accumulate on the range hood, with the
consequent risk of fire.

1. METAL GREASE-TRAPPING FILTERS

These trap the fat and grease particles suspended in the air, and therefore
should be washed every month in hot water and detergent, without bend-
ing them. Wait until they are completely dry before repositioning them.
To remove and replace these filters, see the instructions in point H1. This
operation should be performed at regular intervals.
3. CLEANING THE OUTSIDE OF THE APPLIANCE
The ouside of the range hhod should be cleaned using a damp cloth and
neutral liquid detergent or denatured alcohol.
In case of fingerprint-less finish (fasteel) clean only with water and neutral
soap using clean with a soft cloth, rinse and wipe dry thoroughly. Do not use
products that contain abrasive substances, rough cloths or cloths specifically
designed for cleaning steel. Using abrasive substances or rough cloths will
inevitably damage the finish of steel. The steel surface will be irrevocably
damaged if the instructions above are not complied with.
Keep these instructions together with the instructions for use of your hood.
The manufacturer accepts no liability for any damage caused by non-compli-
ance with the instructions above.
10
ASSEMBLY AND REPLACEMENT

Publicidad

Tabla de contenido
loading

Tabla de contenido