Cafe CWE23SP2MS1 Manual Del Propietario E Instrucciones De Instalación página 32

Installation Instructions
INSTALLING THE REFRIGERATOR (Cont.)
Anti-Tip Floor Bracket Installation (Models CYE and CWE only)
LOCATING THE ANTI-TIP
AT-2
FLOOR BRACKET (cont.)
Figure 2 – Acceptable Screw Placement
Recommended Installation
– Wood
Minimum Acceptable #1 –
Wall Plate Stud
Minimum Acceptable #3
ANTI-TIP BRACKET
AT-3
INSTALLATION
A
WOOD Wall and Floor Construction:
pilot holes in the center of each floor bracket
hole being used (a nail or awl may be used if
a drill is not available) AND remove the locator
template from the floor.
• Mount the anti-tip floor bracket by fastening the
2, or recommended 4, #10-16 hex-head screws
tightly into place as illustrated in Figure 3.
Figure 3 – Attachment to Wall and Floor
Rear RH Corner
of the Refrigerator
32
Locations
Recommended Installation
– Concrete
Minimum Acceptable #2
– Wood Floor
– Concrete Floor
2 Screws
Floor
Must Enter
Bracket
Wood or
Metal Stud
Floor
CONCRETE Wall and Floor Construction:
B
• Anchors required (not provided):
• Drill the recommended size holes for the
anchors into the concrete at the center of the
holes marked in Step 2.
• Install the sleeve anchors into the drilled holes.
Place the anti-tip floor bracket as indicated in Step
2. Remove the locator template from the floor.
• Install the lag bolts through the anti-tip floor
bracket and tighten appropriately.
C
WOOD Wall and TILE Floor Construction:
• For this special case, locate the 2 wall holes
pilot hole (approx. as shown in Fig. 3) in the
center of each hole.
• Mount the anti-tip floor bracket using the
Minimum Acceptable Installation #1, as
illustrated in Fig. 2.
POSITIONING THE
AT-4
REFRIGERATOR TO ENGAGE
THE ANTI-TIP FLOOR AND
BASE BRACKETS
Before pushing the refrigerator into the opening,
A
plug the power cord into the receptacle and
connect waterline (if equipped). Check for leaks.
B
Locate the refrigerator's RH side and move back
approximately in line with the RH side of the
cabinet opening, W. This should position the
anti-tip floor bracket to engage the anti-tip base
bracket on the refrigerator.
Gently roll the refrigerator back into the cabinet
C
opening until it comes to a complete stop.
Check to see if the refrigerator front lines up
with the cabinet front face. If not, carefully rock
the refrigerator forward and backward until
engagement occurs and you notice that the
refrigerator is fully pushed up against the rear wall.
If Applicable: Adjust the rear (and front) wheel
D
height settings to fully engage the rear anti-tip
Wall
brackets, while also aligning the refrigerator
front with the cabinet front face.
Wall
Plate
NOTE: If you pull the refrigerator out and away from
Stud
the wall for any reason, make sure the anti-tip floor
bracket is engaged when the refrigerator is pushed
back against the rear wall.
49-60820-1