Tripp-Lite U444-CAT-H El Manual Del Propietario página 3

Installation
1. Connect the receiver unit to your HDMI display.
Note: If the green LED does not illuminate after installation is completed, additional
power is required. Connect a user-supplied USB Micro-B cable to the available USB
Micro-B port on the receiver unit.
2. Using a Cat6 patch cable (such as Tripp Lite N202-Series cable, not
included), connect the RJ45 port on the transmitter unit to the RJ45 port on
the receiver unit.
3. Connect the transmitter unit to your USB Type-C source (ex. laptop or
tablet). Both the green LED (indicating power is being supplied) and orange
LED (signal transmission is occurring) on both the transmitter unit and
receiver unit should illuminate at this time.
4. (Optional) Using an HDMI cable (such as Tripp Lite P568-Series cable, not
included), connect a local HDMI monitor to the available local HDMI port on
the transmitter unit.
5. (Optional) Prevent your USB Type-C device from unintentional shutdowns
or battery drain by connecting the source's included power adapter to the
available USB-C port on the transmitter unit.
6. If necessary, adjust the video quality on your extended monitor using the EQ
control located on the receiver unit.
Note: An improper equalization setting can cause the monitor to not display an
image. Try each equalization setting until an acceptable image is displayed.
Troubleshooting
1. An image is not displayed on my remote monitor.
Adjust the equalization settings on the receiver unit until an acceptable
image displays, or add power by connecting a user-supplied USB Micro-B
cable to the available USB Micro-B port on the receiver unit.
Specifications
Transmitter Unit Ports
Receiver Unit Ports
Max Resolution
Audio Support
Transmission Distance
HDMI Signal
Operating Temperature
Storage Temperature
Relative Humidity
19-01-469-933939.indb 3
USB Type-C (M), USB Type-C (F), HDMI (F), RJ45 (F)
HDMI (M), RJ45 (F), USB Micro-B (F)
1920 x 1080 @ 60 Hz (1080p)
PCM 7.1, DTS & Dolby 5.1
150 ft. (45 m)
HDMI 1.4, HDCP 1.4
32° to 104°F (0° to 40°C)
5° to 122°F (-15° to 50°C)
0% to 85% RH, Non-Condensing
3
2/12/2019 10:47:04 AM