Midea MAD20S1QWT Manual Del Usuario página 10

Mode Button:
Press this button to change the mode of the
dehumidifier between Set mode, Max mode,
and Continuous run mode.
Set – The dehumidifier runs until the humidity
setpoint has been reached. The dehumidifier
will begin running once the humidity rises
above the setpoint again.
Max – The dehumidifier will run continuously
on High Fan.
Continuous – The dehumidifier will run
continuously and the fan speed can be
changed in this operating mode.
NOTICE
While operating on continuous and Max
modes, the humidity setpoint cannot be
adjusted manually.
Fill Level Button:
Press this button to change the required
water level before the bucket full switch
activates. The options will fill approximately
to the amounts shown in the table below:
Fill Models
level MAD20S1QWT
1.5 gallons
1
(17 lb)
2 gallons
2
(21 lb)
2.75 gallons
3
(27.5 lb)
3 gallons
4
(29.5 lb)
Choose the option which is most comfortable
for you when emptying the bucket.
When the bucket is full, the Display will show
P2. The weights above are approximate
weights of the bucket when filled with the
corresponding volume of water.
 Page 10 
Models
MAD35S1QWT
MAD50S1QWT
MAD50PS1QWT
MAD50PS1QGR
2.25 gallons
(24 lb)
3 gallons
(30 lb)
3.75 gallons
(36.5 lb)
4.25 gallons
(40.5 lb)
NOTICE
For accurate fill levels, ensure the bucket
is empty before beginning operation.
Bucketless mode:
Bucketless mode allows you to run the
unit without the bucket in place. The
included drain hose or a garden hose
must be attached and sloped towards
the drain for proper bucketless mode
operation. Figure 6 shows a proper slope
while figure 7 shows an improper slope.
The drain must be located below the
dehumidifier. For best drain performance,
we recommend the end of the drain hose
be 4 inches below the hose connection.
To activate bucketless mode, the following
steps must be completed within three
minutes of plugging the dehumidifier in.
1. Press and hold the up and fill level
buttons for 3 seconds until the
bucketless icon appears on the display.
2. Ensure the dehumidifier is on a flat
level surface (free of debris).
3. Make sure the hose for Bucketless
mode is sloped down to the drain
(see fig. 6) and does not rise above
the connection point (see fig. 7).
To remove the unit from bucketless
mode, place the unit back on the bucket.
Fig. 6
Fig. 7