Safety Instructions - Auping Aureo K2 Manual De Instrucciones

What you will find in this
instruction manual
• Your Aureo components.
• Attaching the bed lamp to the Auping
K2/Match mesh base.
• Operating the Aureo.
• Aureo with dimmer.
• Replacing the halogen bulb.
• Replacing the floor light.
• Auping warranty.
Your Aureo components
1. Bed lamp with cord
2. Transformer plug (with
ENEC certificate)
3. Rod for automatic ad-
justment with bracket.
4. Plastic insert strip.
5. Interchangeable
lampshade.
6. Allen key (in lamp
base).
7. Long screws
mounting onto K2/
Match mesh
type 11 (flat).
Conversion of
the lamp to
the opposite
side of the
mesh base
The Aureo bed lamp is
available in a left or right hand version. It is pos-
sible to convert the Aureo from one side of your
bed to the other, although we recommend con-
tacting your dealer if you wish to make this con-
version.
GB6
2112 BinnenW.pdf - pag.6
5
7
3
for
2
base
6
LET OP !!! Lage resolutie!

Safety instructions

• Check that the voltage used by the light is the
same as the main voltage in your home.
• Disconnect the Aureo bed light from the
power supply before cleaning or replacing a
light bulb. Remove the plug from the socket.
• Make sure that the cord cannot get trapped.
• Lay the cord so that no one can trip over it.
• Do not use the Aureo bed light as a means of
support to pull yourself up out of bed.
• Be careful with small children who may play
on or under the bed.
• Do not cover the transformer and avoid con-
tact with floor and/or wall.
• Do not fit more powerful bulbs than those
prescribed.
Attaching the bed lamp to
the Auping K2/Match mesh
base
• Place the back section of your K2/Match
mesh base in the most upright position.
• From underneath, slide the lamp base round
the side tube of the mesh base, place the lamp
base at a location where it cannot be touched
by moving parts of the K2/Match mesh base.
Take care, when using the Aureo in combinati-
on with the Auronde bed model, to attach the
bed lamp at a distance of at least 3 cm from
the head end unit.
• Slide the clamp strip A between the side tube
1
and the lamp base B (fig. 1). The lamp now
remains suspended.
• Adjust the lamp to a vertical position
(fig. 2).
4
• Tighten the screws with the enclosed Allen
key (fig. 3).
May 30, 2006